LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1890 (Driveshaft -- F250-F550 Super Duty) >> Disassembly And Assembly >> Driveshaft Universal Joint - Front Slip Yoke >> Assembly >> Bearing cup installation

Bearing cup installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Install the Universal Joint Kits as complete assemblies only. Do not mix components from other kits.
  1. Install a new spider and bearing cup.
    1. Start a new bearing cup in the shaft yoke.
      • Check the needle bearings for correct positioning.
    2. Position the new spider in the shaft yoke.
    3. Press the bearing cup to just below the snap ring groove.
    2. Fig 1: Identifying Spider And Bearing Cup
    GF0006254Courtesy of FORD MOTOR CO.
    NOTE: Use the yellow snap rings supplied in the kit to assemble the U-joint. If difficulty is encountered with the yellow snap rings, install the black snap rings.
  2. Remove the shaft from the special tool, and install the new snap ring.
    3. Fig 2: Locating Snap Ring
    G03883359Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals