LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1887 (Rear Drive Axle/Differential - Ford 10.50-Inch Ring Gear -- F250-F350 Super Duty) >> Removal And Installation >> Differential Carrier >> Removal

Differential Carrier: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the axle shafts. For additional information, refer to Axle Shaft .
  2. Remove the differential cover.
    3. Fig 1: Identifying Differential Bearing Cap And Differential Bearing Cap Bolts
    G03878679Courtesy of FORD MOTOR CO.
    CAUTION: Index-mark the position of the differential bearing caps, as arrows may not be visible. The differential bearing caps must be installed in their original locations and positions.
  3. Remove the differential bearing cap bolts and the differential bearing caps.
    4. Fig 2: Wood Blocks Between Pry Bars & Axle Housing
    GF0006512Courtesy of FORD MOTOR CO.
    WARNING: Be careful not to allow the differential assembly to fall.
    CAUTION: Place a wood block between the pry bar and the axle housing to protect the machined surface from damage.
    CAUTION: Index-mark the position of the differential bearing shims. The differential bearing shims must be installed in their original locations and positions.
  4. Using pry bars and wood blocks, remove the differential assembly from the axle housing.
scientia non olet · About LEMON Manuals