Differential Bearings: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the differential carrier assembly. For additional information, refer to Differential Carrier .

Fig 1: Removing Differential Bearings Using Special Tools

Courtesy of FORD MOTOR CO.

Using the special tools, remove the differential bearings.
- Place the left and right differential bearing shims with the respective outboard spacers.

Fig 2: Index-Marking Driveshaft Flange To Pinion Flange

Courtesy of FORD MOTOR CO.

To maintain driveline balance, index-mark the driveshaft flange and the pinion flange.

Fig 3: Locating Bolts On Driveshaft

Courtesy of FORD MOTOR CO.

Remove and discard the 4 bolts.

Fig 4: Disconnecting Driveshaft Flange Yoke From Pinion Flange

Courtesy of FORD MOTOR CO.

CAUTION: The driveshaft flange fits tightly on the pinion flange. Using a suitable tool, pry only in the area shown to disconnect the driveshaft flange or damage to the driveshaft may occur.

NOTE: It may be necessary to tap the driveshaft flange with a plastic or rubber soft-faced hammer if a pry area is not on the driveshaft flange.

Using a suitable tool as shown, disconnect the driveshaft flange from the pinion flange and support the driveshaft using mechanic's wire.

Fig 5: Holding Pinion Flange With Special Tool

Courtesy of FORD MOTOR CO.

NOTE: Index-mark the pinion flange to the pinion shaft prior to removal.

Use the special tool to prevent the flange from turning, remove the locknut and washer.

Fig 6: Removing Pinion Flange Using Special Tool

Courtesy of FORD MOTOR CO.

Using the special tool, remove the pinion flange.

Fig 7: Driving Pinion From Outer Pinion Bearing

Courtesy of FORD MOTOR CO.

NOTE: There are drive pinion bearing preload shims on the splined-end of the pinion shaft. These drive pinion bearing preload shims can stick to the pinion shaft, the pinion bearing or they can fall out of the axle housing. Collect and keep the drive pinion bearing preload shims for reassembly.

Using the special tool, drive the pinion from the outer pinion bearing and remove it through the rear of the axle housing.

Fig 8: Inner Pinion Bearing And Special Tool

Courtesy of FORD MOTOR CO.

Using the special tool and a suitable press, remove the inner pinion bearing.

Fig 9: Removing Pinion Seal Using Special Tools

Courtesy of FORD MOTOR CO.

Using the special tools, remove and discard the drive pinion seal.
Remove the drive pinion oil slinger, the outer drive pinion bearing and the pinion preload adjustment shims.

Fig 10: Removing Outer Pinion Bearing Cup

Courtesy of FORD MOTOR CO.

CAUTION: Do not nick the axle housing bore or damage to the component may occur.

Using the special tools, remove the outer pinion bearing cup.

Fig 11: Removing Inner Pinion Bearing Cup

Courtesy of FORD MOTOR CO.

Using the special tools, remove the inner pinion bearing cup.