LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1883 (Front Disc Brake System - F250-F550 Super Duty) >> Removal And Installation >> Front Disc Brake >> Removal >> Single rear wheel vehicles

Single rear wheel vehicles

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If the brake disc cannot be removed easily, apply penetrating and lock lubricant on the brake disc-to-wheel hub mating surfaces.
  1. Mark a wheel stud and the corresponding brake disc stud hole.
    • This helps make sure the lowest front brake disc runout is maintained during reassembly.
    2. Fig 1: Marking Wheel Stud And Corresponding Brake Disc Stud Hole
    GF0006166Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals