LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1874 (Manual Transaxle/Transmission And Clutch - General Information - F-150) >> Removal And Installation >> Clutch Pressure Plate Locating Dowels >> Removal

Clutch Pressure Plate Locating Dowels: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Take care not to damage the flywheel dowel holes or surface areas around the flywheel dowel during removal.
  1. Remove the flywheel dowels by using a drift pin where the flywheel dowel is installed in an open hole and locking pliers where the flywheel dowel is installed in a blind hole.
    2. Fig 1: Locating Clutch Pressure Plate Dowels
    GF0001003Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals