LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1873 (Transfer Case - F-150 & Mark LT) >> In-Vehicle Servicing >> Transfer Case Rear Output Shaft Seal >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
    2. NOTE: Index-mark the rear driveshaft yoke and pinion flange to maintain initial driveshaft balance during installation.
  2. Remove the rear driveshaft. For additional information, refer to DRIVESHAFT article.
  3. Using a suitable tool, remove the transfer case rear output shaft seal.
    Fig 1: Removing Transfer Case Rear Output Shaft Seal
    GF0004050Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
    • Using the special tool, install the oil seal.
    Fig 2: Installing Oil Seal Using Special Tool
    GF0004051Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals