LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Automatic Transmission External Controls - F150 & Mark LT) >> Removal And Installation >> Transmission Selector Lever - Column Shift >> Removal

Transmission Selector Lever - Column Shift: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING COLUMN article.
  2. Remove the screw and the lower steering column shroud.
  3. Fig 1: Removing Screw And Lower Steering Column Shroud
    GF0003789Courtesy of FORD MOTOR CO.
  4. Remove the 2 screws and the upper steering column shroud.
  5. Fig 2: Locating Upper Steering Column And Screws
    GF0003790Courtesy of FORD MOTOR CO.
  6. Disconnect the overdrive cancel switch electrical connector.
  7. Fig 3: Disconnecting Overdrive Cancel Switch Electrical Connector
    GF0003798Courtesy of FORD MOTOR CO.
  8. Remove the retaining screw and remove the selector lever.
  9. Fig 4: Locating Selector Lever And Retaining Screw
    GF0003799Courtesy of FORD MOTOR CO.