LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Automatic Transmission External Controls - F150 & Mark LT) >> Removal And Installation >> Transmission Selector Lever - Column Shift >> Installation

Transmission Selector Lever - Column Shift: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the selector lever in the steering column and install the screw.
    • Tighten to 20 Nm (15 lb-ft).
      • Fig 1: Locating Selector Lever And Retaining Screw
      GF0003799Courtesy of FORD MOTOR CO.
    2. CAUTION: Route the overdrive cancel switch wire harness carefully to prevent damage to the wire harness.
  2. Connect the overdrive cancel switch electrical connector.
    3. Fig 2: Locating Overdrive Cancel Switch Electrical Connector
    GF0003798Courtesy of FORD MOTOR CO.
  3. Position the upper steering column shroud and install the 2 screws.
    4. Fig 3: Locating Upper Steering Column Screw
    GF0003790Courtesy of FORD MOTOR CO.
  4. Position the lower steering column shroud and install the screw.
    5. Fig 4: Locating Lower Steering Column Screw
    GF0003789Courtesy of FORD MOTOR CO.
  5. Install the steering wheel. For additional information, refer to STEERING COLUMN article.
scientia non olet · About LEMON Manuals