LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Automatic Transmission External Controls - F150 & Mark LT) >> Removal And Installation >> Transmission Control (TC) Switch - Floor Shift >> Removal

Transmission Control (TC) Switch - Floor Shift: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lift the center console lid cover and remove the console finish panel.
    2. Fig 1: Locating Console Finish Panel
    GF0003780Courtesy of FORD MOTOR CO.
  2. Depress the bottom of the button. Using a suitable tool, pry forward on the top of the selector lever button and remove the button.
    3. Fig 2: Locating Selector Lever Button
    GF0003810Courtesy of FORD MOTOR CO.
  3. Remove the screw, slide the selector lever knob up and remove the selector lever knob.
    4. Fig 3: Locating Selector Lever Knob
    GF0003811Courtesy of FORD MOTOR CO.
  4. Remove the selector lever knob shroud.
    5. Fig 4: Locating Selector Lever Knob Shroud
    GF0003812Courtesy of FORD MOTOR CO.
  5. Disconnect the transmission control (TC) switch electrical connector, release the selector lever bezel locking tabs and remove the selector lever bezel from the selector lever.
    6. Fig 5: Locating TC Switch Electrical Connector
    GF0003813Courtesy of FORD MOTOR CO.
  6. Release the 2 tabs and push the TC switch through the selector lever bezel.
    7. Fig 6: Locating TC Switch
    GF0003814Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals