LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1871 (Automatic Transmission External Controls - F150 & Mark LT) >> Removal And Installation >> Selector Lever Bezel >> Installation

Selector Lever Bezel: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the TC switch in the selector lever bezel.
    2. Fig 1: Identifying TC Switch In Selector Lever Bezel
    GF0003815Courtesy of FORD MOTOR CO.
  2. Install the selector lever bezel on the locking tabs and connect the TC switch electrical connector.
    3. Fig 2: Locating TC Switch Electrical Connector
    GF0003813Courtesy of FORD MOTOR CO.
  3. Install the selector lever knob shroud.
    4. Fig 3: Locating Selector Lever Knob Shroud
    GF0003812Courtesy of FORD MOTOR CO.
    CAUTION: Do not overtighten the screw or damage to the selector lever knob can occur.
  4. Install the selector lever knob and install the screw.
    5. Fig 4: Locating Selector Lever Knob
    GF0003811Courtesy of FORD MOTOR CO.
  5. Position the selector lever button in place and press in on the top of the button to install.
    6. Fig 5: Identifying Selector Lever Button Position
    GF0003816Courtesy of FORD MOTOR CO.
  6. Install the center console finish panel.
    7. Fig 6: Locating Console Finish Panel
    GF0003780Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals