Removal And Installation
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
- Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
- Using a suitable suction device, drain the brake fluid reservoir.
- Disconnect the brake fluid level switch electrical connector.
- Disconnect the 2 brake tubes from the master cylinder.
- To install, tighten to 17 Nm (13 lb-ft).
- Remove the 2 master cylinder nuts.
- To install, tighten to 25 Nm (18 lb-ft).
- To install, reverse the removal procedure.
- Bleed the brake system. For additional information, refer to BRAKE SYSTEM - GENERAL INFORMATION article.
NOTE:
Cap the brake tubes and plug the master cylinder ports.