LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1866 (Anti-Lock Brake System - F150 & Mark LT) >> Diagnostic Tests >> Anti-Lock Control >> Principles of Operation

Principles of Operation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

The ABS module prevents wheel lockup by automatically modulating the brake pressure to the brake calipers during an emergency stop. By not locking the wheels, the driver can improve steering control during hard braking and stop the vehicle in the shortest possible distance under most conditions.

The ABS controls the front and rear brakes separately. The brake pedal force required to engage the ABS function may vary with the road surface condition. A dry surface requires greater force than a slippery surface.

During the ABS operation, the driver may feel a pulsation in the brake pedal, accompanied by a slight up and down movement in the pedal height. In addition, a mechanical noise from the engine compartment may be heard. The pedal effort and pedal feel during normal braking are similar to that of a conventional power brake system.

When the brakes are applied, brake fluid is forced from the brake master cylinder outlet ports to the hydraulic control unit (HCU) inlet ports. The fluid pressure is transmitted through 3 normally open solenoid valves inside the HCU, through the outlet ports of the HCU and finally to the brake calipers. One circuit of the brake master cylinder feeds the front brakes while the other circuit feeds the rear brakes. If the ABS module senses that a wheel is about to lock, based on wheel speed sensor data, the solenoid valve will pulse closed, preventing more fluid from entering that circuit. The ABS module then reads the sensor signal from the affected wheel again. If the wheel is still decelerating, the normally closed solenoid valve for that circuit is opened. A controlled amount of hydraulic pressure between the normally open valve and the brake caliper is relieved into the HCU accumulator. Once the speed of the affected wheel matches the speeds of the other wheels, the ABS module returns the solenoid valves to their normal condition, allowing fluid flow to the affected brake caliper.

The ABS module monitors the electromechanical components of the system. A malfunction of the system will cause the ABS module to shut off or inhibit the system. However, normal power-assisted braking remains. Malfunctions are indicated by the yellow ABS warning indicator in the instrument cluster.

The ABS is self-monitoring. When the ignition switch is placed in the RUN position, the ABS module carries out a preliminary self-check on the anti-lock electrical system indicated by a 3-second illumination of the yellow ABS warning indicator in the instrument cluster.

A self-test of the solenoid valve coils and the pump motor is carried out when the vehicle is started. During starting, the brake pedal must be released to run the self-test. If the brake pedal is applied or a failed brake switch occurs, the self-test is run at 6 km/h (4 mph) regardless of brake pedal position.

When installing a new ABS module, the following "as built data" items must be configured into the new module:

scientia non olet · About LEMON Manuals