Clutch Disc and Pressure Plate: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Adjust the clutch pressure plate as follows:
- Rotate the adjusting ring counterclockwise until the tension springs are compressed.
- Hold the adjusting ring, then release the pressure on the clutch pressure plate fingers.
Fig 1: Adjusting Clutch Pressure Plate
Courtesy of FORD MOTOR CO.
Using the special tool, position the clutch disc on the flywheel.

Fig 2: Positioning Clutch Disc On Flywheel

Courtesy of FORD MOTOR CO.

NOTE: If installing the original clutch pressure plate, use the index marks made during removal.

Position the clutch pressure plate on the dowels, install the clutch pressure plate bolts and remove the special tool.
- Tighten to 55 N.m (41 lb-ft).

Fig 3: Positioning Clutch Pressure Plate On Dowels

Courtesy of FORD MOTOR CO.

Install the transmission. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION article.
- Before securing the transmission to the engine, install the hydraulic line to the clutch slave cylinder.
Operate the vehicle to check clutch operation.