Fuel System Pressure Release
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) | software with appropriate hardware, or equivalent scan tool |
- Disconnect the splash shield and position aside.
- Disconnect the electrical connector.
- Start the engine and allow it to idle until it stalls.
- After the engine stalls, crank the engine for approximately 5 seconds to make sure the fuel rail pressure has been released.
- Turn the ignition switch to the OFF position.
- When fuel system service is complete, connect the electrical connector.
- Reposition the splash shield and install a new pushpin.
- Cycle the ignition key and wait 3 seconds to pressurize the fuel system. Check for leaks before starting the engine.
- Install the scan tool. Turn the key ON with the engine OFF. Cycle the key OFF, then ON. Select the appropriate vehicle and engine qualifier. Clear all diagnostic trouble codes (DTCs) and carry out a PCM reset.
- Start the vehicle and check the fuel system for leaks.
NOTE:
The splash shield is located on the LH frame rail under the driver side door.
NOTE:
It may take more than one key cycle to pressurize the fuel system.