LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1851 (Safety Belt System - F-150 & Mark LT) >> Removal And Installation >> Safety Belt Buckle - Front, Center >> Regular cab safety belt buckle

Regular cab safety belt buckle

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the RH upper seat side trim panel screw and trim panel.
  2. Remove the RH lower seat side trim panel screw and trim panel.
  3. Remove the safety belt buckle bolt and safety belt buckle.
    • To install, tighten to 55 Nm (41 lb-ft).
    • The anti-rotation tab must be correctly aligned for correct installation.
scientia non olet · About LEMON Manuals