LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1851 (Safety Belt System - F-150 & Mark LT) >> Diagnostic Tests >> Safety Belt System >> Component Test >> Functional Test - Automatic Locking Retractor

Functional Test - Automatic Locking Retractor

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: After any vehicle collision, the safety belt system at all seating positions (except driver, which has no automatic locking retractor [ALR] feature) must be checked by a qualified technician to verify that the ALR feature for child seats is still functioning correctly, in addition to other checks for correct safety belt system function. A new safety belt assembly must be installed if the safety belt assembly's ALR feature or any other safety belt function is not operating correctly when checked according to the procedures in the workshop manual. Failure to install a new safety belt retractor assembly could increase the risk of injury in collisions.
  1. Position the seat back into the FULL UP position.
  2. Position the height adjuster (if equipped) in the FULL DOWN or UP position.
  3. Latch the seat belt buckle and tongue assembly.
  4. Pull the shoulder belt out until the ALR feature is activated.
    5. NOTE: Some seat mounted safety belt retractors may exhibit a slow retraction speed condition. It is not necessary to replace the safety belt retractor for this condition. Refer to Safety Belt Cleaning  in this section, for the concern.
  5. Release the shoulder belt and allow it to retract until it stops.
  6. Pull on the shoulder belt to check that the belt has remained in the ALR mode. If the belt is not locked, install a new safety belt assembly.
  7. Unlatch the safety belt tongue from the buckle and allow the safety belt to retract to its stowed position.
  8. Pull the shoulder belt to verify the retractor assembly has converted automatically out of the ALR mode. If the shoulder belt remains locked in the stowed position, install a new safety belt retractor assembly.
scientia non olet · About LEMON Manuals