LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1848 (Steering Column Switches - F-150 & Mark LT) >> Removal And Installation >> Steering Column Multifunction Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING COLUMN article.
  2. Remove the lower steering column shroud screw.
  3. Apply inward pressure to the upper and lower shroud cover seam to separate them and remove the lower shroud.
    Fig 1: Identifying Lower Shroud
    GF0004287Courtesy of FORD MOTOR CO.
  4. Remove the 2 screws and the upper steering column shroud.
  5. Remove the screw, release the tab and position the multi-function switch aside.
    Fig 2: Positioning Multi-Function Switch
    GF0004288Courtesy of FORD MOTOR CO.
  6. Disconnect the multi-function switch electrical connector.
  7. Remove the multi-function switch.
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals