Seat Position Sensor - Power Seat Track

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Seat Position Sensor (Power Seat Track)

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	14C719	Seat position sensor connector
2	-	Seat position sensor nuts
3	14B416	Seat position sensor

WARNING: Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.

WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.

NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.

NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic procedure again.

NOTE: The seat position sensor is mounted at the LH rear of the seat track. Position the driver seat rearward enough so that upon removal the sensor can clear the bracket.

Position the driver seat to access the seat position sensor.
Depower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of this section.
Fold the seat backrest all the way forward.
Disconnect the seat position sensor electrical connector.
Remove the nuts and seat position sensor.
- To install, tighten to 8 Nm (71 lb-in).
To install, reverse the removal procedure.
Repower the SRS. Refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of this section.
- After installation and power is restored, position the driver seat from its forward most position to its rearmost position and then back again. While positioning the seat, make sure that the seat position sensor, bracket and wire harness do not come in contact with any other part of the seat that may cause damage.