Passenger Air Bag Deactivation (PAD) Indicator
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Part Number | Description |
|---|---|---|
| 1 | 1504302 | Instrument panel center finish panel |
| 2 | 14401 | Connector |
| 3 | - | Screw (3 required) |
| 4 | 14B418 | Passenger air bag deactivation (PAD) indicator |
WARNING:
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
NOTE:
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in this article.
- Remove the instrument panel center finish panel.
- Disconnect the passenger air bag deactivation (PAD) indicator electrical connector.
- Remove the PAD indicator screws and PAD indicator.
- To install, reverse the removal procedure.
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in this article.