LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Supplemental Inflatable Restraint System - F-150 & Mark LT) >> Removal And Installation >> Driver Air Bag Module >> Installation

Driver Air Bag Module: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: The clockspring electrical connectors are unique and cannot be reversed when connected to the driver air bag module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the driver air bag module.
  1. Install the driver air bag module.
    • Connect the horn electrical connector.
    • Connect the black driver air bag module electrical connector.
    • Connect the gray driver air bag module electrical connector.
      CAUTION: Make sure the driver air bag module wiring lays over the steering wheel bolt and does not get trapped while positioning the driver air bag module to the steering wheel.
    • Position the driver air bag module to the steering wheel.
    2. Fig 1: Identifying Driver Air Bag Module
    GF0002224Courtesy of FORD MOTOR CO.
  2. Install the 2 driver air bag module bolts.
    • Tighten to 10 Nm (89 lb-in).
  3. Install the 2 driver air bag module bolt caps.
  4. Repower the system. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  in the General Procedures portion of this section.
scientia non olet · About LEMON Manuals