LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1844 (Supplemental Inflatable Restraint System - F-150 & Mark LT) >> Removal And Installation >> Clockspring >> Removal

Removal And Installation: Clockspring: Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.
NOTE: The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a SRS fault.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic procedure again.
  1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  in the General Procedures portion of this section.
  2. Make sure the road wheels are in the straight-ahead position.
  3. Remove the driver air bag module. For additional information, refer to Driver Air Bag Module  in this article.
  4. Remove the steering wheel. For additional information, refer to STEERING COLUMN article.
  5. Remove the screw and lower steering column shroud.
  6. Remove the 2 upper steering column shroud screws and upper steering column shroud.
  7. If installing the same clockspring, apply 2 strips of masking tape across the clockspring to prevent accidental rotation when the clockspring is removed.
  8. Remove the multi-function switch screw.
  9. Remove the screw and the multi-function switch.
    • While releasing the retaining tab at the top of the multi-function switch, slide the multi-function switch up and aside.
  10. Disconnect the clockspring electrical connectors.
  11. Release the 3 clips and remove the clockspring.
    12. Fig 1: Locating Clips
    GF0002229Courtesy of FORD MOTOR CO.
  12. Inspect the clockspring mounting bracket for damage and install a new mounting bracket as necessary.
    • To install, tighten to 6 Nm (53 lb-in).
scientia non olet · About LEMON Manuals