LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1840 (MULTIFUNCTION Electronic Module - F-150 & Mark LT) >> Removal And Installation >> Vehicle Security Module (VSM) - Regular Cab >> Installation

Vehicle Security Module (VSM) - Regular Cab: Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the VSM and install the 2 screws.
    • Tighten to 7 Nm (62 lb-in).
  2. Connect the 3 (built before 12/2006) or 2 (built after 12/2006) VSM electrical connectors.
  3. Install the LH B-pillar trim panel.
    4. NOTE: When successful, this step provides the calibration necessary for the VSM operation and clears DTC B2477. The clearing of the DTC indicates the calibration data has been successfully downloaded to the VSM.
  4. Download the VSM configuration information from the scan tool to the VSM. For additional information, refer to MODULE CONFIGURATION article.
    5. NOTE: When successful, this step clears DTCs B2868, B2869, B2870 and B2871. The clearing of these DTCs indicates the VSM has recognized the tire pressure sensors during the training procedure.
  5. Train the tire pressure sensors. For additional information, refer to WHEELS AND TIRES article.
    6. NOTE: DTC C2780 will not clear if any other DTCs are present in the VSM.
    NOTE: This step is required to clear DTC C2780, allow the VSM to exit the manufacturing mode, and to make sure there are no other concerns with the newly programmed VSM.
  6. Carry out the VSM on-demand self-test by clearing DTCs and then retrieving DTCs to confirm all DTCs have been cleared.
scientia non olet · About LEMON Manuals