Rear seat cushion
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- If equipped with a rear subwoofer, remove the 3 fasteners (2 shown).
- If equipped, rotate the subwoofer forward and disconnect the electrical connector.
- Remove the 2 rear seat riser-to-floor outboard nuts.
- Remove the 2 rear seat riser-to-floor inboard nuts.
- Remove the 2 rear seat outboard riser-to-floor bolts.
- With the seat in the normal sitting position, lift the seat cushions up for access to the rear seat front attachment fasteners.
- Remove the rear seat center riser-to-floor bolt.
- Remove the rear seat cushion assembly.
CAUTION:
Do not operate the vehicle with the rear seat cushion removed. The 2 rear outboard nuts hold the chassis to the frame, and the chassis may move if driven. Discard the 2 outboard nuts and install new.