LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1835 (Seat System - F-150 & Mark LT) >> Removal And Installation >> Seat - Rear >> Installation >> Rear seat cushion

Rear seat cushion

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear seat cushion assembly in the vehicle.
  2. Install the rear seat center riser-to-floor bolt.
    • Tighten to 48 Nm (35 lb-ft).
  3. Install the 2 rear seat riser-to-floor outboard bolts.
    • Tighten to 80 Nm (59 lb-ft).
  4. Install the 2 rear seat riser-to-floor inboard nuts.
    • Tighten to 80 Nm (59 lb-ft).
  5. Install 2 new rear seat riser-to-floor outboard nuts.
    • Tighten to 80 Nm (59 lb-ft).


  1. If equipped with a rear subwoofer, connect the electrical connector and rotate the subwoofer rearward.
    Fig 1: Connecting Electrical Connector And Rotating Subwoofer Rearward
    GF0001918Courtesy of FORD MOTOR CO.
  2. If equipped, install the 3 subwoofer fasteners (2 shown).
    Fig 2: Locating Subwoofer Fasteners
    GF0001917Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals