Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure the fog lamp switch and ignition switch are in the OFF position.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Remove the 3 bolts and the fog lamp bracket.
- Disconnect the fog lamp electrical connector.
- Remove the adjuster screw and spring.
Release the tabs and the fog lamp assembly.
To install, reverse the removal procedure.
- If necessary, adjust the fog lamps. For additional information, refer to Front Fog Lamp Adjustment in this article.