LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1831 (Exterior Lighting System) >> General Procedures >> Headlamp Adjustment >> Headlamp Aiming

Headlamp Aiming

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. The headlamp aiming procedure depends on what type of beam pattern the headlamp is equipped with. To identify the headlamp beam pattern, look on the headlamp lens. Molded in small letters on the headlamp lens is one of the following:
    • SAE (identified by lack of VOL or VOR marking)
    • VOL
    • VOR
  2. Once the headlamp beam pattern is identified, aim the headlamps using one of the following methods as applicable.
    • Photometric aimers can aim SAE, VOL and VOR type headlamps. This is the preferred method of headlamp aiming.
    • Visual or screen method aiming can be used to aim SAE, VOL and VOR type headlamps.
    • Mechanical aimers can only be used with SAE type headlamps. Lamps that can be aimed mechanically will have 3 nibs molded into the lens of the lamp.
scientia non olet · About LEMON Manuals