LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1831 (Exterior Lighting System) >> Diagnostic Tests >> Parking, Rear and License Plate Lamps >> Pinpoint Tests >> Pinpoint Test Q: The Parking, Rear Or License Plate Lamps Are On Continuously >> Pinpoint Test Q: The Parking, Rear Or License Plate Lamps Are On Continuously

Pinpoint Test Q: The Parking, Rear Or License Plate Lamps Are On Continuously

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Q1 CHECK THE HEADLAMP SWITCH 
    • Disconnect: Headlamp Switch C2150a
    • Do the parking lamps continue to illuminate? 
    1. YES  : If equipped with autolamps, go to  Q2 .

      If not equipped with autolamps, REPAIR circuit 14 (BN). TEST the system for normal operation.

    2. NO  : INSTALL a new headlamp switch. REFER to Headlamp Switch  in this article. TEST the system for normal operation.
  2. Q2 CHECK CIRCUIT 14 (BN) FOR SHORT TO POWER 
    • Disconnect: VSM C3008a
    • Do the parking lamps continue to illuminate? 
    1. YES  : REPAIR the circuit. TEST the system for normal operation.
    2. NO  : Go to  Q3.
  3. Q3 CHECK FOR CORRECT VSM OPERATION 
    • Disconnect all the VSM connectors.
    • Check for:
      • corrosion
      • damaged pins
      • pushed-out pins
    • Connect all the VSM connectors and make sure they seat correctly.
    • Operate the system and verify the concern is still present.
    • Is the concern still present? 
    1. YES  : INSTALL a new VSM. REFER to MULTIFUNCTION ELECTRONIC MODULES article. TEST the system for normal operation.
    2. NO  : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.