LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1822 (Engine System - General Information - F-150 & Mark LT) >> General Procedures >> Crankshaft Main Bearing Journal Taper and Out-of-Round

Crankshaft Main Bearing Journal Taper and Out-of-Round

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to the appropriate Engine for the specification.
  1. Measure each of the crankshaft main bearing journal diameters in at least 2 directions at each end of the main bearing journal.
    Fig 1: Measuring Crankshaft Journal Diameters
    GF0000181Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals