LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1821 (Exhaust System - F-150 & Mark LT) >> Removal And Installation >> Exhaust Y-Pipe - Dual Catalytic Converter >> Installation >> 4.6L and 5.4L engine

4.6L and 5.4L engine

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure to apply anti-seize lubricant to the threads of the sensors before installation.
    NOTE: A special tool is available for use in installing the HO2S. An open-end wrench can be used for ease of installation.
  1. Install the LH HO2S sensor.
    • Tighten to 40 Nm (30 lb-ft).
scientia non olet · About LEMON Manuals