LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine - 4.2L - F-150) >> Installation >> Engine >> Installation >> Vehicles equipped with an automatic transmission

Vehicles equipped with an automatic transmission

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure the marks made on the torque converter stud and the flexplate are lined up.
  1. Position the engine in the vehicle and mate it to the transmission.


    NOTE: Rotate the crankshaft using the crankshaft pulley bolt to access all of the torque converter nuts.
    Fig 1: Locating Torque Converter Nuts
    GF0002479Courtesy of FORD MOTOR CO.
  1. Install the 4 torque converter nuts.
    • Tighten to 36 Nm (27 lb-ft).
  2. Install the cylinder block opening cover.
    Fig 2: Locating Cylinder Block Opening Cover
    GF0002478Courtesy of FORD MOTOR CO.


  1. Attach the transmission cooler tubes to the bracket.
    Fig 1: Attaching Transmission Cooler Tubes To Bracket
    GF0002474Courtesy of FORD MOTOR CO.


  1. Connect the fuel vapor tubes to the purge valve.
    Fig 1: Connecting Fuel Vapor Tubes To Purge Valve
    GF0002458Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals