LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Push Rod >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. Remove the rocker arms. For additional information, refer to Rocker Arm  in this article.
    2. CAUTION: If the push rods are to be reused, they must be installed in their original locations. Mark the push rods for location.
  2. Remove the push rods.
  3. Inspect the push rods. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
    4. NOTE: Lubricate the push rods with clean engine oil.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals