LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Oil Pump >> Removal

Oil Pump: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Drain the engine oil. Install the drain plug when finished.
    • Tighten to 23 Nm (17 lb-ft).
  3. Remove and discard the oil filter.
  4. Remove the 6 bolts and the oil pump.
    5. CAUTION: Do not reuse the oil pump seal. A new service seal must be installed.
    Fig 1: Removing Oil Pump Seal
    GF0002431Courtesy of FORD MOTOR CO.
  5. Remove and discard the oil pump seal.
  6. Remove and inspect the oil pump drive gear, the driven gear and the cover. Install new components if necessary.
    Fig 2: Locating Oil Pump Drive Gear, Driven Gear And Cover
    GF0002432Courtesy of FORD MOTOR CO.
  7. Inspect the face of the oil pump for flatness.
    Fig 3: Inspecting Face Of Oil Pump
    GF0002433Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals