LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Oil Pump >> Installation

Oil Pump: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new service oil pump seal on the oil pump.
    2. NOTE: Lubricate the parts with clean engine oil before assembly.
    Fig 1: Locating Oil Pump Drive Gear, Driven Gear And Cover
    GF0002432Courtesy of FORD MOTOR CO.
  2. Install the oil pump drive gear, the driven gear and the cover.
  3. Position the oil pump and install the bolts. Tighten the bolts as shown.
    • Tighten to 10 Nm (89 lb-in).
    • Tighten to 28 Nm (21 lb-ft).
    Fig 2: Positioning Oil Pump And Installing Bolts
    GF0002434Courtesy of FORD MOTOR CO.
  4. Install a new oil filter.
    • Tighten to 16 Nm (12 lb-ft).
  5. Fill the engine with clean engine oil.
scientia non olet · About LEMON Manuals