LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Exhaust Manifold - RH >> Removal

Exhaust Manifold - RH: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the RH heated oxygen sensor (HO2S). For additional information, refer to ELECTRONIC ENGINE CONTROLS article.
  3. Detach the exhaust manifold-to-EGR system module tube from the exhaust manifold.
  4. Remove the bolts and detach the dual converter Y-pipe.
  5. Remove the nuts and the engine lifting eye.
  6. Remove the nuts, the RH exhaust manifold and the gasket. Discard the nuts and the gasket.
    7. NOTE: Note the locations of the 2 long studs.
  7. Remove and discard the 6 RH exhaust manifold studs.
scientia non olet · About LEMON Manuals