LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Cylinder Head >> Removal >> LH cylinder head

LH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped, remove the A/C compressor. For additional information, refer to CLIMATE CONTROL article.
  2. Remove the 2 A/C compressor and power steering bracket brace nuts.
  3. Remove the A/C compressor and power steering bracket brace upper bolt. Loosen the lower bolt and position it forward until it contacts the power steering pulley. Position the A/C compressor and power steering bracket brace aside.
  4. Loosen the remaining A/C compressor and power steering bracket bolt. Position it forward until it contacts the power steering pulley and position the A/C compressor and power steering bracket aside.
  5. Remove the LH exhaust manifold. For additional information, refer to Exhaust Manifold - LH  in this article.
  6. Disconnect the knock sensor (KS) and cylinder head temperature (CHT) sensor electrical connectors. Detach the HO2S electrical connector retainer from the rear of the LH cylinder head.
  7. Remove the push rods from the LH cylinder head. For additional information, refer to Push Rod  in this article.
scientia non olet · About LEMON Manuals