LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Cylinder Head >> Installation >> LH cylinder head

LH cylinder head

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the push rods in the LH cylinder head. For additional information, refer to Push Rod  in this article.
  2. Connect the KS and CHT electrical connectors. Attach the HO2S electrical connector to the rear of the LH cylinder head.
  3. Install the LH exhaust manifold. For additional information, refer to Exhaust Manifold - LH  in this article.
  4. Position the A/C compressor and power steering bracket and loosely install the bolt.
  5. Position the A/C compressor and power steering bracket brace and install the 2 bolts. Tighten all 3 bolts.
    • Tighten to 48 Nm (35 lb-ft).
  6. Install the A/C compressor and power steering bracket brace nuts.
    • Tighten to 25 Nm (18 lb-ft).
  7. If equipped, install the A/C compressor. For additional information, refer to CLIMATE CONTROL article.
scientia non olet · About LEMON Manuals