LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1819 (Engine - 4.2L - F-150) >> In-Vehicle Servicing >> Crankshaft Pulley >> Installation

Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a bead of silicone gasket and sealant to the keyway in the crankshaft damper and use the special tool to install the crankshaft damper.
    Fig 1: Installing Crankshaft Damper
    GF0002385Courtesy of FORD MOTOR CO.
  2. Using the special tool to prevent crankshaft rotation, install the bolt.
    • Tighten to 160 N.m (118 lb-ft).
    Fig 2: Locating Crankshaft Pulley Bolt
    GF0002383Courtesy of FORD MOTOR CO.
  3. Install the fan blade assembly. For additional information, refer to ENGINE COOLING article.
  4. Install the drive belt. For additional information, refer to ACCESSORY DRIVE article.
scientia non olet · About LEMON Manuals