LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1818 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Throttle Position (TP) Sensor - 5.4L (3V) >> Removal

Throttle Position (TP) Sensor - 5.4L (3V): Removal

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the throttle position (TP) sensor electrical connector.
    2. CAUTION: Failure to remove the TP sensor screws in the following manner will result in damage to the screws. First loosen the screws 1-2 full turns using a hand tool and then use a suitable high speed driver to complete the removal.
  2. Remove and discard the 2 screws and the TP sensor.
scientia non olet · About LEMON Manuals