LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1818 (Electronic Engine Control System - F-150 & Mark LT) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor - 4.6L (2V) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the generator. For additional information, refer to GENERATOR AND REGULATOR article.
  2. Disconnect the cylinder head temperature (CHT) sensor electrical connector.
  3. Remove the CHT sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
    • Apply anti-seize to the threads of the CHT sensor.
scientia non olet · About LEMON Manuals