Vehicles equipped with a 4.6L (2V) or 5.4L (3V) engine
WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Detach the battery cable harness retainer from the radiator shroud.
- Disconnect the electronic cooling fan clutch electrical connector.
- Remove the nut and detach the electronic cooling fan clutch wiring harness from the stud bolt.
- To install, tighten to 13 Nm (10 lb-ft).
- Using the special tools, remove the cooling fan assembly and position it in the fan shroud.
- To install, tighten to 55 Nm (41 lb-ft).
CAUTION:
Do not side load the cooling fan clutch coil or the cooling fan clutch may be damaged.