LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1816 (Engine Cooling System - F-150 & Mark LT) >> Removal And Installation >> Cooling Fan - Blade, Clutch and Shroud >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the pin-type retainers and the radiator appearance cover.
    2. Fig 1: Locating Pin-Type Retainers
    GF0002832Courtesy of FORD MOTOR CO.


  1. Remove the bolts and the cooling fan shroud and cooling fan.
    • To install, tighten to 6 Nm (53 lb-in).
  2. If servicing the cooling fan or cooling fan clutch, refer to Cooling Fan and Cooling Fan Clutch  in this article.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals