LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1814 (Fuel Charging And Controls - 4.6L (2V) - F-150) >> Removal And Installation >> Fuel Injectors >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and can be ignited. Failure to follow these instructions can result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before working on or disconnecting any of the fuel tubes or fuel system components, the fuel system pressure must be relieved. Failure to follow these instructions can result in personal injury.
  1. Remove the fuel rail. For additional information, refer to Fuel Rail  in this information.
  2. Remove the 8 fuel injectors.
    3. NOTE: Install new O-ring seals on the fuel injectors.
    NOTE: Lubricate the new fuel injector O-ring seals with clean engine oil prior to installing the fuel injectors.
  3. Remove and discard the 8 lower fuel injector O-ring seals.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals