4WD vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Install the front driveshaft and align the index marks made during removal. Install the 4 bolts.
- Tighten to 103 Nm (76 lb-ft).

Fig 1: Aligning Index Mark On Front Driveshaft

Courtesy of FORD MOTOR CO.

Install the front driveshaft shield and install the 2 nuts.
- Tighten to 18 Nm (13 lb-ft).

Fig 2: Locating Front Driveshaft Shield And Nuts

Courtesy of FORD MOTOR CO.