LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1807 (Automatic Transmission - 4R70E/4R75E - F150 & Mark LT) >> In-Vehicle Servicing >> Extension Housing Gasket >> Removal >> Rear wheel drive (RWD) vehicles

Rear wheel drive (RWD) vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original positions.
  1. Mark the driveshaft flange and the rear pinion flange for correct alignment during assembly.
    2. Fig 1: Locating Driveshaft Flange And Rear Pinion Flange
    GF0003498Courtesy of FORD MOTOR CO.
  2. Remove the 4 rear driveshaft bolts.
Fig 2: Identifying Driveshaft Bolts
G04016647Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals