RWD vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The output shaft and the driveshaft are a balanced assembly.

Install the driveshaft.
- Align the yellow dots and position the driveshaft on the transmission.

Fig 1: Positioning Driveshaft On Transmission

Courtesy of FORD MOTOR CO.

NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.

Install the 4 driveshaft bolts.
- Tighten to 103 Nm (76 lb-ft).

Fig 2: Identifying Driveshaft Bolts

Courtesy of FORD MOTOR CO.