All vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Install the extension housing and gasket.
- Install the extension housing and gasket.
- Install the bolts.
  - Tighten to 27 Nm (20 lb-ft).
Fig 1: Identifying Extension Housing & Gasket
Courtesy of FORD MOTOR CO.
Raise and position the transmission.
Position the rear transmission insulator and install the bolts.
- Tighten to 80 Nm (59 lb-ft).

Fig 2: Locating Rear Transmission Mount And Exhaust Hanger Bolts

Courtesy of FORD MOTOR CO.

Position the crossmember and loosely install the transmission mount-to-crossmember nut.

Fig 3: Identifying Transmission Mount-To-Crossmember Nuts

Courtesy of FORD MOTOR CO.

Install the 4 crossmember-to-frame nuts and bolts.
- Tighten to 115 Nm (85 lb-ft).

Fig 4: Locating Crossmember-To-Frame Bolts

Courtesy of FORD MOTOR CO.

Lower the transmission on the crossmember and tighten the rear mount nuts.
- Tighten to 103 Nm (76 lb-ft).

Fig 5: Identifying Transmission Mount-To-Crossmember Nuts

Courtesy of FORD MOTOR CO.

Install the bolts retaining the exhaust hanger to the crossmember.
- Tighten to 40 Nm (30 lb-ft).

Fig 6: Locating Bolts For Exhaust Hanger

Courtesy of FORD MOTOR CO.

Remove the high-lift transmission jack.

Fig 7: Locating Transmission Jack

Courtesy of FORD MOTOR CO.

Install the bolt for the LH heat shield to the transmission support crossmember.
- Tighten to 20 Nm (15 lb-ft).

Fig 8: Identifying LH Exhaust Shield Bolt

Courtesy of FORD MOTOR CO.

Install the bolt for the RH heat shield to the transmission support crossmember.
- Tighten to 20 Nm (15 lb-ft).

Fig 9: Locating RH Exhaust Shield Bolt

Courtesy of FORD MOTOR CO.

Lower the vehicle.
Fill the transmission with clean transmission fluid.
- Verify for correct operation.
- Check for leaks.