LH cylinder head

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into their original locations.

Remove the hydraulic lash adjusters from the LH cylinder head.
Install the special tool onto the LH cylinder head.

Fig 1: Identifying Special Tool Onto Cylinder Head
Courtesy of FORD MOTOR CO.
Remove the 8 nuts and the LH exhaust manifold.
- Discard the nuts.
- Discard the gasket.
- Inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM - GENERAL INFORMATION article.
Fig 2: Locating LH Exhaust Manifold Nuts And Studs
Courtesy of FORD MOTOR CO.
Remove and discard the 8 LH exhaust manifold-to-cylinder head studs.

Fig 3: Locating LH Exhaust Manifold-To-Cylinder Head Studs
Courtesy of FORD MOTOR CO.