RH cylinder head

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove the special tool from the RH cylinder head.

Fig 1: Identifying Special Tool On Cylinder Head
Courtesy of FORD MOTOR CO.
Install the hydraulic lash adjusters into the RH cylinder head.
- Lubricate the hydraulic lash adjusters with clean engine oil prior to installation.
Fig 2: Identifying Hydraulic Lash Adjusters
Courtesy of FORD MOTOR CO.
Install 8 new RH exhaust manifold-to-cylinder head studs.
- Tighten to 12 Nm (9 lb-ft).
Fig 3: Locating RH Exhaust Manifold-To-Cylinder Head Studs
Courtesy of FORD MOTOR CO.
Position a new gasket, the RH exhaust manifold and tighten the 8 new nuts in the sequence shown.
- Tighten to 25 N.m (18 lb-ft).
Fig 4: Identifying Tightening Sequence Of RH Exhaust Manifold Bolts
Courtesy of FORD MOTOR CO.
Install the coolant tube and the stud bolt.
- Tighten to 10 N.m (89 lb-in).
Fig 5: Identifying Coolant Tube Stud Bolt
Courtesy of FORD MOTOR CO.