LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1806 (Engine - 5.4L (3V) - F-150 & Mark LT) >> In-Vehicle Servicing >> Valve Cover - LH >> Installation >> Early build vehicles

Early build vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: When installing the valve cover, make sure to avoid damaging the VCT solenoid.
    Fig 1: Identifying Tighten Sequence Of Valve Cover Bolts
    G03919871Courtesy of FORD MOTOR CO.
  1. Position the LH valve cover and new gasket on the cylinder head and tighten the fasteners in the sequence shown
    • Tighten to 10 N.m (89 lb-in).
scientia non olet · About LEMON Manuals