LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1806 (Engine - 5.4L (3V) - F-150 & Mark LT) >> In-Vehicle Servicing >> Oil Pan >> Removal >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Drain the engine oil.
  3. Remove the 4 bolts and the frame crossmember.
    Fig 1: Locating Frame Crossmember Bolts
    GF0002772Courtesy of FORD MOTOR CO.
  4. Detach the starter wiring harness support bracket.
    Fig 2: Detaching Starter Wiring Harness Support Bracket
    GF0002669Courtesy of FORD MOTOR CO.


    NOTE: Be careful when removing the oil pan gasket. It is reusable.
    Fig 1: Identifying Oil Pan Bolts And Gaskets
    GF0000321Courtesy of FORD MOTOR CO.
  1. Remove the 16 bolts, the oil pan and the gaskets.
    • Inspect the oil pan gasket for damage.
    • If damaged, discard the oil pan gasket and the oil pan-to-oil pump gaskets.
scientia non olet · About LEMON Manuals